QUALITY TESTS

Oxidation Layer Testing

Keg Neck Angle Testing

Corrosion Test, Salt Solution

45 Degree Drop Test

Spectrum Testing of Raw Material

Neck Angle Retaintion Test

Pressure Test, Point of Failure

85 Degree Drop Test

---

1. All raw materials are tested before use
2. Checked for imperfections after each step
3. Visual inspection of all kegs inside and out; prior to and after passivation
4. All kegs go through a 2 step, 3 hour passivation process to ensure Chromium Oxide layer is well above 65 NM 
5. Every keg is pressure tested to 5 Bars or higher
6. Measurements are taken to ensure all kegs meets requirements
7. Follow strict 6 Sigma quality control protocols
8. Kegs are pulled from each batch to test for points of failure to ensure they meet our high quality standards

---

---

WARRANTY

Standard KEGS LLC warrants that its kegs will be free from defects in material and workmanship, under normal use and regular service, and preventative maintenance for the Warranty Period of 5 Years. As specified below, valves which are not made by Standard KEGS LLC are warranted by their respective manufacturer; therefore, this Limited Warranty does not apply to such parts.

What is covered:

• Rust of weld lines 
• Dislocation of chimes under normal use
• Collapse of keg neck 
• Failure of keg body and chimes
• Leak of keg body due to metal fatigue under normal use conditions
• Stress fractures
• Leak of kegs under normal operation pressure

​What is not covered:

• Normal wear and tear
• Failure of valves and seal
• Damage to kegs due to mishandling
• Use outside of its designed function (i.e. use the kegs to hold anything other than beer, water, wine, or soda)
• Malicious or intentional damage

---